Author Topic: fuse holder broken  (Read 900 times)

Sarge5706

  • Newbie
  • *
  • Posts: 2
    • View Profile
fuse holder broken
« on: March 28, 2019, 07:35:29 PM »
New to forum and this might have been covered somewhere already but....I have a Quicksilver 8.0 and I have snapped off one of the clips that holds the 30amp fuse in place.  IMO it is a poor design.  Has anyone else had this problem and if so how did you rectify or fix it.  Thank you in advance

rrtrntowing

  • Newbie
  • *
  • Posts: 19
    • View Profile
Re: fuse holder broken
« Reply #1 on: April 23, 2019, 08:52:34 AM »
Newbie, I'm sure you have a meaningful comment to make.  But if your comments are not in English, few people will understand them.

Sarge5706

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: fuse holder broken
« Reply #2 on: April 28, 2019, 09:54:53 AM »
Pretty sure I typed it in English.  If you did not understand what I was saying, perhaps you should ask for clarification or work on your comprehension skills.

rrtrntowing

  • Newbie
  • *
  • Posts: 19
    • View Profile
Re: fuse holder broken
« Reply #3 on: April 28, 2019, 11:11:53 AM »
Not sure how my comment got placed below your question but it has been.  I was actually commenting on an entry that was in a foreign language and wasnt about your question.  Apologies anyway, though not aimed at you.

Kasey00

  • Newbie
  • *
  • Posts: 5
    • View Profile
Re: fuse holder broken
« Reply #4 on: May 07, 2020, 04:42:33 AM »
You should be turning off the breaker at the pedestal before plugging in or disconnecting. People have been badly vidmate shocked doing it with the breaker on and it appears you are getting a surge when you are doing it causing your problem.