Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Bejinscbr

Pages: [1] 2 3
You aren't the only one. There is a sticker on the door itself somewhere. Get a picture of that and contact Challenger Door in Indiana. If you have that sticker, they can get you an exact replacement. Make sure you tell them it's for a Livin Lite trailer. Pricing should be around $450-$500, then there is shipping as well.

CampLite Travel Trailers / Re: rear access hatch for FK11
« on: October 11, 2021, 07:31:22 AM »
Can you get a picture of it and post?

And here are a couple pictures.

It was in mine when I got it. 1 for each tip-out. This is on a 2014 toyhauler model. Also had it on a 2013 toyhauler.

It is for a 12volt light. It plugs in there, has a flexible cord, and clips onto the tip-out pole. I'll try to get a picture of mine soon.

General Q & A / Re: Weight Distribution Hitch for 2013 Camp Lite 16DB
« on: September 19, 2021, 07:56:21 PM »
First question would be, do you a need a WDH hitch for that trailer? It weighs around 3000 lbs dry with 350 lbs tongue weight. You may not need it at all, even with the Colorado. Have you been towing it and noticed issues?

For Sale / 2014 Livin Lite Quicksilver 8.5'x24' for sale
« on: September 02, 2021, 11:07:09 AM »
Selling my 2014 Livin Lite Quicksilver toyhauler.
8.5' wide x 24' long, 86" ceiling height
Overall length with tongue is 28'.
Weighs around 5400 lbs dry, 8000 GVWR.
Garage space is 14' to fridge. 20' to front kitchen. 78" between wheelwells.

This is an all aluminum trailer, frame, sides, and roof. The floor is aluminum plank, strong and won't ever go "soft"

Dual tip-out beds, one on each side.
Couch and dinette both fold down for sleeping, or up against the wall for loading ATV's etc.
A/C, furnace, water heater, TV, radio, 120v/propane fridge, convection microwave, and outside shower hookup.
Bathroom is a dry bath, with sink and storage inside.
Dual propane tanks
single battery (new)
4 new tires, and the spare
New maxxair vent covers on all vents

Trailer is great, spacious inside when tip-out are folded out. Plenty of storage.
Only selling because I found a front bedroom model.
Only negative is corrosion on the entry door. I have a new door on order from the original manufacturer. It will be replaced before sale unless buyer says different.
Price is $29k obo.
I'll have to text pics, can't get them to load yet.
Can help with delivery up to about 100 miles with an upfront deposit.

QuickSilver Toy Haulers / Re: Quicksilver Dealerships
« on: August 26, 2021, 09:15:37 PM »
They stopped making them several years ago. The only ones you will find now are used.
Go on the Livin Lite Facebook group and post there. Maybe someone will be fairly close by with one you can see.

QuickSilver Toy Haulers / Re: Looking for a 6x15 toy hauler in Southwest
« on: August 26, 2021, 09:14:32 PM »
There is one for sale in Florida. Not close by, but I don't see these for sale very often. Good luck.

CampLite Travel Trailers / Re: Frame Separated from Tongue
« on: August 22, 2021, 09:39:14 PM »
I personally think the weight distribution hitches put too much stress on these aluminum trailers. There have been multiple times this has happened and I think most people were using them. And they really don't need them for something with 350-450 lbs tongue weight. Don't tow with a small SUV where you need to use distribution hitches and I think they are okay.
If you think about it, the weight bars are forcing the tongue to stay in one spot in relation to the vehicle. What happens when going over bumps, driveways, etc? The trailer can't move and something has to give. The forces are multiplied even more. Lots of stress on fairly thin aluminum tubing. Without them, the trailer is free to move with bumps.
Now, a sway bar, sure. That should be fine. But obviously, it's up to the owner to use a weight distribution hitch or not. Just my two cents.

RV store should have them. Measure the width of the old one first and get the same if possible. The one I bought was too wide and didn't fit. I had to trim the corners off so it would. You would need to be able to get to the backside of it to get the water connections off as well. Of course, make sure the pump is off first and/or city water turned off. It will make a small mess. 

FYI, price has gone up. Just paid ~$700 for one for my toyhauler. It is irritating, but I also didn't buy mine new, so I knew about this going into it. If I had bought new, I would be pretty upset.

CampLite Travel Trailers / Re: Hail Damage
« on: August 08, 2021, 12:28:15 AM »
Check the roof. As long as it's just dents, no big deal. Just cosmetic at that point. If it has holes/penetrations, then you would have to seal them and monitor just as you would any other roof hole/seam (vent covers, plumbing vent, edges, etc). Replace the sealant when it starts to look bad. Up to you if it bothers you or not. Obviously the value of the trailer would be lower, so should be able to get a decent deal. Good luck.

QuickSilver Tent Campers / Re: any quicksilver tc1's for sale?
« on: July 03, 2021, 12:33:28 AM »
Livin Lite sold out to Thor and then was basically shut down several years later.  So no, they aren't made anymore. Closest in concept is ATC trailer.
The TC1's are out there. I've seen several in the last year online. Seem to run about $3k. Check Facebook marketplace (change your location to different areas that you are willing to drive to, craigslist by using searchtempest.

Pages: [1] 2 3