Livin' Lite Forum

QuickSilver => General Q & A => Topic started by: Gettinrad on June 22, 2019, 11:00:46 PM

Title: Wall studs on 2017 VRV 7x20
Post by: Gettinrad on June 22, 2019, 11:00:46 PM
Does anyone know the layout of the studs along the side walls of a 7x20 Quicksilver VRV?  I checked some of the things that are currently mounted to the walls like the baseboard and the fold up couch but can't seem to get any uniform measurement.  They should be either 12 or 16 inches.  I have a few things I would like to mount to the walls like more cabinets and a fold down table.
Title: Re: Wall studs on 2017 VRV 7x20
Post by: Bejinscbr on June 29, 2019, 10:51:01 PM
Dan at livin lite had said to start measuring from the rear. It's 1.5"-3"(I'm not sure on this) wide in the rear and then goes to 16" centers going towards the front. At least on the older units this is what they are. If you have a fold down couch/bed, you can start there and figure them out.