Dan, I have a troubling problem I hope you can help me with. My trailer has the new covered underbelly. Through social media I have been made aware of trailers with a welds failing and bolts being loose on the fresh water tank supports. I took 3 of the bolts down from the edge of the underbelly at the front end of the trailer and was able to to see the center water tank support where it bolts to the frame. One of the bolts is very obviously loose. I cannot see far enough down to visually inspect the rest. This leads me to an important safety issue. How can I possibly get in there to tighten this bolt, and for that matter to inspect and/or maintain the entire underside of my trailer. The material is all one piece, and is tucked securely above the frame on the sides with no access whatsoever. The front and the back have bolts that allow about 1 1/2" of space to barely peer in. I am very concerned.
This is a zoomed in photo from my iPhone from the front under my battery to the area near the axel where the water tank is.
This is a zoomed in photo from my iPhone from the front under my battery to the area near the axel where the water tank is.