Messages

We had 30psi in the coil spring rear air lifts. It road level.

The wife and I picked up the trailer in Maryland and traveled on, spending a month camping in Virginia, NC, Georgia and Florida as a "short" shakedown trip. The camper performed flawlessly. We loved it. We camped in temperatures from 18F (dry camping) to 85F, in all kinds of weather.

It towed fine behind the Sienna with no WDH, just a sway bar.

We would still be interested in the history of our trailer if the prior reads this. We bought it at Beckley's in Maryland.

Now onto the Pacific Northwest with our kids in May (sleeping in the van and the trailer). We plan on roaming around for three months.

Thanks

I installed air levelers in the back shocks, so I can level the van.

We will pick up the trailer next week (and see it for the first time!).

Thanks,

Thank you Mitch!

I still would appreciate the following information, should someone be able to measure their 2013 13QBB tongue frame.

2. What are the dimensions of the aluminum frame? I want to make plates to sandwich the frame (with dielectric material, then steel) for mounting the sway bar ball plate.

When we pick up the trailer, I want to have a bracket ready to bolt the sway bar plate.

Thanks,

Great answers, thanks for your Help Dave! I did calculate the GCWR and it was close. We will try to limit what we carry.

The trailer we bought is at Beckley's in Maryland, we have yet to go down and get it. If anyone out there is the prior owner, we would be interested in the history of the trailer.

We recently bought a 2013 13QBB.

1. What size hitch ball does it take? I have read 2-5/16 on the forum, but the manual calls for a 2".

2. What are the dimensions of the aluminum frame? I want to make plates to sandwich the frame (with dielectric material, then steel) for mounting the sway bar ball plate.

3. What size are the wheel lug nuts?

4. What type grease does the factory use for the wheel bearings?

5. Do you think we need a WD hitch? We will be towing it with a 2014 Sienna minivan with a pull capacity of 3500# and a max tongue weight of 350#. We have a family of four with a family weight of approximately 575# (had to estimate the boss ).


Thanks for your help.

Buddy,
Did you sell it?
   [email protected]

Thanks,

Paul

Buddy,
I also sent you an email.
Thanks,

Paul,
Did you end up trading this to a dealer or is it still for sale?
Thanks